WP 001 – Spears and Mace

Description

WP 001 – Spears and Mace – by LootBOX+

This is a resin SLA 3d printed add on for kits/toys. Printed using high quality ABS like resin.

Design for 1/100 scale kits

WP01A – 3 parts, 8.74″(222mm) long, tip to tip

WP01B – 2 parts, 10.9″(277mm)long, tip to tip

WP01C – 2 parts, 9.33″(237mm)long, tip to tip

Note:

For rescaling, contact us through our socials.

Instagram: gxalhobbies.store

Whatsapp: +965 55776088

Email: gxalhobbies@gmail.com

# Post-Processing
• Handle with care! 3D-printed resin parts will break if excessively flexed, particularly at room temperature.
• Just like epoxy-based resin parts, these parts can be safely submerged in warm water to help with correcting warp.
• Part fitment may be tight in some areas. Trimming the pegs in question first will prevent issues. CA glue can be used to easily repair breaks or fill pits or holes.
• To smooth the layer lines present with 3D-printed resin parts, light sanding, followed by a surfacing primer should be used, when necessary.

# Health Disclaimer:
• Resin is dangerous when airborne. Proper safety gear, including a respirator with particulate filters should be worn when sanding resin parts.